Vauxhall Corsa Manuel du propriétaire télécharger pdf (Page 176)

Vehicle care 175

on your vehicle to ensure that the

replacement or alternate tyres and

wheels allow the tyre pressure

monitoring system to continue to

function properly.

The use of commercially available

liquid tyre repair kits can impair the

function of the system. Factory

approved repair kits can be used.

System initialisation

After a wheel change or tyre pressure

adjustment the system must be

initialised: inflate the cold tyres to the

prescribed pressure according to the

tyre information label or this

document 3 217. Then switch on

ignition and press and hold the DDS

button for approx. 4 seconds. The

control indicator A flashes three

times.

If the tyre pressure difference

between the left and the right wheel

on one axle is more than 30 kPa, tyre

pressure monitoring system

malfunction will be indicated, as the

vehicle starts moving for the first time

after initialisation. Adjust tyre

pressure and repeat initialisation.

Note

The system needs to be initialised

after tyre pressure change,

otherwise it will not be able to warn

properly.

Each time the tyres are replaced, the

tyre pressure monitoring system

sensors have to be dismounted and

serviced. For the screwed sensor

replace the valve core and sealing

ring, for the clipped sensor replace

complete rubber valve stem.

Auto learn function

After changing wheels the vehicle

must be stationary for approx.

20 minutes, before the system

recalculates. The following relearn

process takes up to 10 minutes of

driving with a minimum speed of

16 mph.

Tyre deflation detection

system

The tyre deflation detection system

continually checks the rotation speed

of all four tyres.

If a tyre loses pressure the control

indicator w illuminates red. Stop

immediately and check tyre pressure.

Control indicator w 3 83.

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 228 229

Commentaires sur ces manuels

Pas de commentaire