Vauxhall Corsa Manuel du propriétaire Page 91

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 229
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 90
90 Instruments and controls
Vehicle messages
Messages are given via the
instrument panel display or as
warning and signal buzzers. Check
control messages appear on the
Info-Display. Some appear in an
abbreviated form. Confirm warning
messages with the multifunction knob
3 86.
Warning chimes
When starting the engine or
whilst driving
If seat belt is not fastened.
If a door or the tailgate is not fully
closed when starting-off.
If a certain speed is exceeded with
the parking brake applied.
If the speed programmed at the
factory is exceeded.
If the vehicle has manual
transmission automated and the
driver's door is opened when the
engine is running, a gear is
engaged and the foot brake is not
depressed.
Warning signal sounds three times
if the rear carrier system is
extended and reverse gear is
selected.
When the vehicle is parked and
the driver's door is opened
When the key is in the ignition
switch.
With exterior lights on.
For manual transmission
automated, if the parking brake is
not applied and no gear is engaged
when the engine is switched off.
During an Autostop
If the driver's door is opened.
Battery voltage
Low battery voltage in the radio
remote control. On vehicles without
check control, the message InSP3
appears in the instrument panel
display. Replace the battery 3 20.
Brake light switch
Brake light does not come on during
braking. Have the cause of the fault
remedied immediately by a
workshop.
Drain diesel fuel filter
If there is water in the diesel fuel filter,
the message InSP4 appears in the
instrument panel. In some models
InSP4 illuminates together with A in
the instrument. Consult a workshop.
Lighting
Important exterior lighting lamps,
including cables and fuses, are
monitored. In trailer mode, trailer
lighting is also monitored. Trailers
with LED lighting must have an
adapter that enables lamp monitoring
as with conventional bulbs.
Vue de la page 90
1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 228 229

Commentaires sur ces manuels

Pas de commentaire